Hot Search: Welding electrodes for carbon steel Welding electrodes for stainless steel
 |
| According with GB E410-15 Corresponding with AWS E410-15 | |||||||||||||||||||||
| Introduction: E410-15 is a kind of Cr13 stainless steel electrode with basic coating. DCRP (Direct Current Reversed Polarity). All-position welding. | |||||||||||||||||||||
| Uses: Used for welding 0Cr13, 1Cr13 and 2Cr13 stainless structures, such as repair welding and butt welding on blades of steam turbines. Also used for corrosion-resistant and wear-resistant surface overlaying. | |||||||||||||||||||||
| Chemical Composition of Deposited Metal (%)
| |||||||||||||||||||||
Mechanical Properties of Deposited Metal(The temperature of the test pieces should be preserved under 730-760℃ for an hour, and then they should be cooled along with the furnace to 315℃ at a speed of not higher than 60℃/h, and finally cooled in the air.)
| |||||||||||||||||||||
Reference Current(DC+)
| |||||||||||||||||||||
| Instructions: 1.The electrodes must be baked under about 350-400℃ for an hour before welding. 2.The stains on the weldments, such as rust, oil stains, moisture, etc., must be cleared away before welding. 3.The weldments should be preheated to 300-350℃ before welding, and tempered under 680-760℃ after welding. | |||||||||||||||||||||
| According with GB E410-15 Corresponding with AWS E410-15 | |||||||||||||||||||||
| Introduction: E410-15 is a kind of Cr13 stainless steel electrode with basic coating. DCRP (Direct Current Reversed Polarity). All-position welding. | |||||||||||||||||||||
| Uses: Used for welding 0Cr13, 1Cr13 and 2Cr13 stainless structures, such as repair welding and butt welding on blades of steam turbines. Also used for corrosion-resistant and wear-resistant surface overlaying. | |||||||||||||||||||||
| Chemical Composition of Deposited Metal (%)
| |||||||||||||||||||||
Mechanical Properties of Deposited Metal(The temperature of the test pieces should be preserved under 730-760℃ for an hour, and then they should be cooled along with the furnace to 315℃ at a speed of not higher than 60℃/h, and finally cooled in the air.)
| |||||||||||||||||||||
Reference Current(DC+)
| |||||||||||||||||||||
| Instructions: 1.The electrodes must be baked under about 350-400℃ for an hour before welding. 2.The stains on the weldments, such as rust, oil stains, moisture, etc., must be cleared away before welding. 3.The weldments should be preheated to 300-350℃ before welding, and tempered under 680-760℃ after welding. | |||||||||||||||||||||
